模具彈簧
Mold Springs
顏色是判斷彈簧承載力的最直接依據。顏色越深,承載力越強、允許壓縮量越小
選型與安裝需注意:
- 核對行程:先計算工作行程與所需彈力,再挑選對應顏色的彈簧。
- 控制壓縮比:例如綠色彈簧的工作壓縮量建議控制在自由高度的 24% 以內(其他顏色依等級調整,黃色可較大、棕色需更小)。
- 保留間隙:模具合死時,彈簧圈之間必須保留縫隙,絕不能壓到完全實心。
Color is the most direct indicator of a spring’s load capacity. The darker the color, the higher the load capacity and the smaller the allowable deflection ratio
Key Considerations for Selection & Installation:
- Verify Stroke: Calculate the required working stroke and spring force first, then select the corresponding color code.
- Control Deflection Ratio: For example, the recommended working deflection for green springs should be kept within 24% of the free length (other colors scale accordingly—yellow allows more, brown requires less).
- Maintain Clearance: When the mould is fully closed, clearance must remain between the spring coils; never compress the spring to its solid height.




